Sun Microsystems 1800 Computer Accessories User Manual


 
24 Netra ft 1800 Installation Guide February 1999
FIGURE 2-11 Module Injector/ejector Lever
The module is disengaged from its electrical connection when the slide is moved
towards the rounded end of the lever, exposing the red warning dot.
The general procedure refers to CPUset, CAF, PCI and PSU modules. For more
specific instructions for the RMM and disk chassis, refer to:
“Replacing an RMM” on page 30
“Replacing a Disk Chassis” on page 32
To Remove a Module
1. Move the slide in the lever on the module to the disengaged position.
This will expose the red warning dot.
2. Lower the lever.
The module will slide out a small amount when the lever is fully lowered.
3. Slide the module out of its slot, using the handle if there is one.
For specific procedures relating to individual modules, refer to:
“CPUset Modules” on page 25
“CAF Modules” on page 27
“PCI Modules” on page 28
“PSU Modules” on page 29
Open
Closed
Red warning dot