Filter
Top Products
Appendix C Installing the Sun PCI-Express Dual Gigabit Ethernet Device Driver on Linux Platforms 85
▼ To Configure VLANs in a Linux Environment
1. Ensure that the e1000 module is loaded:
2. Plumb the Sun PCI-Express Dual Gigabit Ethernet interface:
where
xxx.xxx.xx.xxx = the IP address of the interface.
3. Insert the VLAN module:
4. Add the VLAN instance (VID):
5. Configure the e1000 VLAN (eth2 in this example):
where
xxx.xxx.xx.xxx = the IP address of the interface.
# modprobe e1000
# ifconfig eth2 xxx.xxx.xx.xxx up
# /sbin/modprobe 8021q
# /sbin/vconfig add eth2 5
# ifconfig eth2.5 xxx.xxx.xx.xxx up