Filter
Top Products
Installations
11
2.1.3 Setting Jumpers
There are jumpers on the system board of the F815D Series. You can
set the jumpers to make the necessary operations.
Figure 6: Jumper Connector
For any three-pins jumpers (Figure 6), the jumper setting is 1-2 when
the jumper connects pin 1 and 2. The setting is 2-3 when pin 2 and 3 are
connected and so on. You see one of the lines surrounding jumpers is thick,
which indicates pin NO.1.
To move a jumper from one position to another, use needle-nose pliers
or tweezers to pull the pin cap off the pins and move it to the desired
position.