16 Sun StorageTek 8 Gb FC PCI-Express HBA, Emulex Installation Guide • December 2008
Testing the Installation
This section contains the following topics:
■ “To Verify Proper Installation (for the Solaris OS)” on page 17
■ “To Verify Attached Storage (for the Solaris OS)” on page 21
▼ To Verify Proper Installation (for the Solaris OS)
1. Use the show-devs command at the ok prompt to list the installed devices.
The HBA can be identified in the output by looking for the SUNW,emlxs@n and
SUNW,emlxs@n,1 node names, where n is usually a single-digit number from 0
to 9. In this example, there are two dual port (SG-XPCIE2FC-EM8-Z) and one
single port (SG-XPCIE1FC-EM8-Z) HBAs installed.
Slow Blink Off Normal – Link Down or not started
Slow Blink On Not Defined
Slow Blink Slow Blink Off-line for Download
Slow Blink Fast Blink Restricted Off-line Mode (Waiting for Restart)
Slow Blink Flashing Restricted Off-line Mode, Test Active
Fast blink Off Debug Monitor in Restricted Mode
Fast blink On Not Defined
{0} ok show-devs
/pci@7c0/pci@0
/pci@7c0/pci@0/pci@9
/pci@7c0/pci@0/pci@8
/pci@7c0/pci@0/pci@2
/pci@7c0/pci@0/pci@2
/pci@7c0/pci@0/pci@1
/pci@7c0/pci@0/pci@9/SUNW,emlxs@0,1
/pci@7c0/pci@0/pci@9/SUNW,emlxs@0
/pci@7c0/pci@0/pci@9/SUNW,emlxs@0,1/fp@0,0
TABLE 2-2 LED Status (Continued)
Green LED Yellow LED State