Filter
Top Products
Chapter 2 Installing and Configuring the Server Module 21
FIGURE 2-1 Inserting the Server Module Into the Chassis
4. Push the server module into the slot until the server module stops.
See
FIGURE 2-1 [2].
5. Rotate the ejectors down until they snap into place.
The server module is now flush with the chassis, and the ejectors are locked. See
boxes 3 and 4 in
FIGURE 2-1 [3,4].
If the chassis is powered on, the server module comes up to standby power. The
green OK LED on the front panel flashes and the blue OK to Remove LED remains
on. See
FIGURE 1-1.
LED Behavior
When the server module is inserted in the chassis, the LEDs blink in a specific
sequence.