Filter
Top Products
54 Sun Blade X6450 Server Module Installation Guide • September 2008
▼ To Modify General Settings With a -Select Utility
● Select Controller Configuration from the main -Select utility menu and change
the settings listed in the following table.
Some options might not be available.
Note – Default settings are shown in bold type.
TABLE B-1 General Settings
Option Description
Drive’s Write Cache When enabled, write cache is enabled on the disk drive. When
disabled, write cache is not used on the disk drive. It is
recommended that you disable write cache on the disk drive.
Caution - When write cache is enabled, there is a slight possibility
of data loss or corruption during a power failure.
Runtime BIOS When enabled, the REM BIOS allows the REM to act as a bootable
device. Disabling the BIOS allows another REM to act as a
bootable device.
Automatic Failover When enabled, the REM automatically rebuilds an array when a
failed disk drive is replaced. When disabled, the array must be
rebuilt manually.
Array Background
Consistency Check
When enabled, the REM constantly verifies a redundant array.
Note that there might be a significant performance reduction.
Default is disabled.
BBS Support When enabled in systems that support BBS, the REM is presented
as a bootable device in the BIOS.
Array-Based BBS
Support
When enabled in systems that support BBS, the REM presents
attached bootable devices up to the BIOS for boot device selection.
This is relevant for logical arrays. Default is disabled.
Physical Drives
Display During
POST
When enabled, connected disk drives are displayed during system
Power On Self Test (POST). Displaying the disk drives adds a few
seconds to the overall POST time. Default is disabled.
CD-ROM Boot
Support
When enabled, the system can be booted from a bootable CD.
Note—CDs are not supported by current software.