Filter
Top Products
Chapter 5: Advanced Serverboard Setup
5-15
Fan Headers
The X7DBU has fi ve eight headers,
designated Fan1 through Fan8. FAN5
through FAN8 are for 4-pin Pulse
Width Modulated (PWM) fans and are
to be connected to the CPU heatsink
fans. Their speed is controlled via
Thermal Management with a BIOS
setting. FAN1 through FAN4 are 3-
pin, non-PWM fans. See the tables
on the right for pin defi nitions.
Serial Ports
The COM1 serial port is located on
the IO backplane. COM2 is a header
on the serverboard (see serverboard
layout for location). See the table on
the right for pin defi nitions.
Note: Pin 10 is included on the header but not on
the port. NC indicates no connection.
Serial Port Pin Defi nitions
(COM1, COM2)
Pin # Defi nition Pin # Defi nition
1 DCD 6 DSR
2RXD 7RTS
3TXD 8CTS
4 DTR 9 RI
5 Ground 10 NC
4-pin Fan Header
Pin Defi nitions
(FAN5-8)
Pin# Defi nition
1 Ground (Black)
2 +12V (Red)
3 Tachometer
4 PWM Control
3-pin Fan Header
Pin Defi nitions
(FAN1-FAN4)
Pin# Defi nition
1 Ground (Black)
2 +12V (Red)
3 Tachometer
Universal Serial Bus
Headers
Three additional USB headers (USB2/
USB3 and USB4) are included on the
serverboard. These may be used for
front side access. A USB cable (not
included) is needed for the connec-
tion. See the table on the right for
pin defi nitions.
Universal Serial Bus Headers
Pin Defi nitions (USB2, USB3, USB4)
USB2
Pin # Defi nition
USB3, USB4
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 Key 5 NC