Filter
Top Products
A-9
:
59h
The Hit <DEL> message is cleared. The <WAIT...> message is displayed.
Starting the DMA and interrupt controller test next.
60h
The DMA page register test passed. Performing the DMA Controller 1
base register test next.
62h
The DMA controller 1 base register test passed. Performing the DMA
controller 2 base register test next.
65h
The DMA controller 2 base register test passed. Programming DMA
controllers 1 and 2 next.
66h
Completed programming DMA controllers 1 and 2. Initializing the 8259
interrupt controller next.
67h
Completed 8259 interrupt controller initialization.
7Fh
Extended NMI source enabling is in progress.
80h
The keyboard test has started. Clearing the output buffer and checking for
stuck keys. Issuing the keyboard reset command next.
81h
A keyboard reset error or stuck key was found. Issuing the keyboard
controller interface test command next.
82h
The keyboard controller interface test completed. Writing the command
byte and initializing the circular buffer next.
83h
The command byte was written and global data initialization has
completed. Checking for a locked key next.
84h
Locked key checking is over. Checking for a memory size mismatch with
CMOS RAM data next.
85h
The memory size check is done. Displaying a soft error and checking for
a password or bypassing WINBIOS Setup next.
86h
The password was checked. Performing any required programming
before WINBIOS Setup next.
87h
The programming before WINBIOS Setup has completed.
Uncompressing the WINBIOS Setup code and executing the AMIBIOS
Setup or WINBIOS Setup utility next.
88h
Returned from WINBIOS Setup and cleared the screen. Performing any
necessary programming after WINBIOS Setup next.
89h
The programming after WINBIOS Setup has completed. Displaying the
power on screen message next.
8Ch
Programming the WINBIOS Setup options next.
8Dh
The WINBIOS Setup options are programmed. Resetting the hard disk
controller next.
8Fh
The hard disk controller has been reset. Configuring the floppy drive
controller next.
91h
The floppy drive controller has been configured. Configuring the hard disk
drive controller next.
Table A-4. Uncompressed Initialization Error Codes
Post Code Description