Filter
Top Products
SUPER PIIIDM6/PIIIDM4/PIIIDM3/PIIIDME Manual
4-18
BIOS
Chassis Fan1
Chassis Fan2
The above features are for PC Health Monitoring. The motherboards with
W83781D have seven onboard voltage monitors for the CPU core, CPU I/
O, +3.3V, +5V, -5V, +12V, and -12V, and for the four-fan status monitor.
OnBoard IDE
This option enables the IDE (Hard Disk Drive Controller) drives(s) on the
motherboard. The settings are
Disabled, Primary, Secondary
and
Both
.
OnBoard FDC
This option enables the FDC (Floppy Drive Controller) on the motherboard.
The settings are
Disabled
and
Enabled
.
OnBoard Serial Port1
This option specifies the base I/O port address of serial port 1. The
settings are
Disabled
,
3F8h
,
2F8h
,
3E8h
and
2E8h
.
OnBoard Serial Port2
This option specifies the base I/O port address of serial port 2. The
settings are
Disabled
,
3F8h
,
2F8h
,
3E8h
and
2E8h
.
Serial Port2 Mode
The settings for this option are
Normal, IrDA SIR-A,. IrDA SIR-B,
ASKIR, Consumer
and
Raw IR
. When set to anything but
Normal,
the IR Duplex Mode becomes available and can be set to
either
Half
or
Full
.
Serial Port2 Duplex Mode
This option is enabled by the selection made in the previ-
ous Serial Port 2 Mode option. This makes the IR Duplex
Mode available, which can be set to either
Half
or
Full
.
Onboard Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are
Auto
(AMIBIOS automatically determines the
correct base I/O port address),
Disabled
,
378h
,
278h
and
38Ch
.
Parallel Port Mode
This option specifies the parallel port mode. The settings are
Normal
,
EPP
and
ECP
. When set to
Normal,
the normal parallel
port mode is used. Use
Bi-Dir
to support bidirectional transfers.
Use
EPP
(Enhanced Parallel Port) to provide asymmetric bidirectional