Filter
Top Products
Turn the coloured ribbon feed knob at the right of the new ribbon
cassette in the direction of the arrow in order to take up slack of
the ribbon.
Slightly tilt the ribbon cassette forwards in such a way that it is
parallel to the housing top and thread in the ribbon in front of
the print head. Locate the two projections in the left and right
guide rails of the printer and gently press down on both sides
until it clicks into place. In this way, the cartridge is automat-
ically positioned correctly.
Use the knob on the right side of the cassette to take up slack of
the ribbon again. Thereby the ribbon will slide over the plastic
noses on the left and right of the print head into the correct
position.
Press the printer bar cover down until it clicks into place,
remount the top cover, making sure that the projections on the
cover are inserted correctly into the recesses of the printer
housing, and close it.
pull to open
pull to open
pull to open
pull to open
Changing the ribbon cassette Quick Start-up
12