Filter
Top Products
Paper handling This section describes how to set the paper type, load fanfold paper and single sheets, trans-
port paper and move the paper to the tear position.
➤ Changing the
paper type
You can change the paper type either from an application program, by means of the paper
path quick selection feature or in the Setup menu. In this section, the quick selection feature
is described; for detailed information on how to make this setting via the Setup menu, refer
to the Reference Manual on the Online CD-ROM.
On some printer models, the single sheet paper source cannot be selected since these models
are not designed for manual single sheet feeding.
Make sure that the printer is in offline mode; press the Online key, if necess-
ary.
Press the Park (1) key. If fanfold paper is loaded in the printer, it is fed to the
tear position. The text tear paper off appears in the display. Then press any
key. If a single sheet is loaded in the printer, it is ejected.
Use one of the marked keys to select the desired paper path, for example,
Single (2).
The printer returns to offline mode. The display alternates between the basic
menu and the menu in the following figure:
Insert a single sheet (for the procedure, see page 17, Loading single sheets).
Press the Online key to set the printer to ready status. When the printer re-
ceives data from the computer, the single sheet is automatically loaded. Press
the Load (4) key to load the single sheet before starting the printout.
Offline Tractor1
Park Load
Online
Setup
21
3
4
Single Tractor
Online
Setup
21
3
4
If you do not make a selection within 5 seconds, the menu is closed.
Load paper from
Single
Online
Setup
21
3
4
Online Single
Load
Online
Setup
21
3
4
Paper handling Quick start-up
14