TANDBERG D12155-10 Webcam User Manual


 
56
TANDBERG Videoconferencing SystemAdvanced use
Request floor
When requesting the floor, the MCU will broadcast your video in full screen to all other participants in the
conference. If the MCU conference has a chairman, a floor request is sent to the chairman.
You will remain ‘On Air’ until either you select ‘Release Floor’ or the chairman decides to release the floor to
another participant.
FLOOR WILL AUTOMATICALLY BE REQUESTED WHEN SENDING A SNAPSHOT OR SELECTING THE DOC CAM OR PC VIDEO SOURCES.
Release floor
You choose ‘Release Floor’ to take you ‘Off Air’. You should do this when you wish to make the floor available to
the other participants in the conference.
Terminal Names
Allows you to see the site numbers or name (if supported) of other sites connected in the conference.
View site # *
Allows you to view any participant in the conference other than the participant currently ‘On Air’.
End view
Allows you to stop viewing the site previously chosen with ‘View Site #’, and returns your view to the site that is
currently ‘On Air’.
* - NOT supported by the MultiSite
TIP
VIEW SITEANDEND VIEWCAN BE USED BY ALL CONFERENCE PARTICIPANTS.
NOTE