Filter
Top Products
D 14724.02 TANDBERG EX90 User Guide (TC3.1) June 2010
25
Outside a call, you may have the unit enter standby mode by touching the Power
button on the main unit (the screen). The Standby dialog is displayed and the unit
enters standby immediately. This does not work when you are in a call.
Outside a call, press the Power button until the Shutdown progress bar is filled
completely.
Release the button and the unit will go in shutdown in just a few seconds.
To revert to the factory default settings, do as follows:
1. Disconnect the power cord.
2. Reconnect the power cord—a green light will illuminate shortly after.
3. Press the Power button as soon as the green light appears. Keep it depressed
for 15 seconds or so, until the green light starts flashing.
4. Release the button and press twice within 2 seconds. All settings will now revert
to factory default settings.
The background image on the inTouch controller can be changed.
Do as follows:
1. Draw a circle with your finger anywhere on the screen where there are no icons.
2. The below image will then appear on the inTouch screen. Tap one of the small
images to use it as background image.
Setting the TANDBERG EX90 in standby
Shutting down the TANDBERG EX90
Reverting to factory default settings
Changing background image on inTouch
Tap the touch
pad to wake up the
system from standby.
To start the system again,
press the Power button
until the LED illuminates
(green light).
What’s in this Guide?
Introduction
Connecting EX90
Using EX90
The Settings
Web interface