Filter
Top Products
Showing the Display Window/Ending Your Current Session and Returning to DOS
2-16
Operating in the Configuration Window
2.13 Showing the Display Window — the Display Command
When you choose the
display command
, the programmer software checks to
to see if a current device type has been selected. If you have selected a current
device type, the programmer sets up the configuration and briefly displays the
following message before returning to the top level command.
Set programmer configuration.....
If you have
not
selected a current device type, the following warning message
is displayed:
Warning: Device not selected, unable to set up the programmer
Press any key to erase the warning; then, use the
choose device
command
to select a current device. You cannot proceed to the display window until a
valid current device has been selected.
2.14 Ending Your Current Session and Returning to DOS — the Quit
Command
Use the
quit
command to exit the programmer software. Before the program-
mer software actually quits, you must confirm that this is what you want to do
at the prompt:
Confirm:
Press to confirm that you really want to quit. Any other key is interpreted
as a retraction of the quit command.