Filter
Top Products
E10-3
10. GENERAL MAINTENANCE
ENGLISH VERSION EM1-33031
■ Cleaning the Cutter Unit
10.3 Removing Jammed Paper
WARNING!
1. Be sure to turn the power off before cleaning the cutter unit.
2. The cutters are sharp and care should be taken not to injure yourself when cleaning.
1. Loosen two screws and remove the cutter cover.
2. Remove the white screw and media guide.
3. Remove the jammed paper and trash.
4. Clean the cutter with dry cloth.
Fig. 10-3
Fixed Cutter
Cutter Unit
Swing Cutter
Screw
Media Guide
Cutter Cover
White Screw
(24741710304)
5. Assembling is reverse order of removal.
Print speed
3"/sec.
5"/sec.
8"/sec.
Ribbon loss
Approx. 5 mm
Approx. 8 mm
Approx. 17 mm
■ Auto Ribbon Saving Mode
Auto ribbon saving function is activated when it is selected by DIP switch (Refer to page 4-1) and no
print area extends more than 20 mm.
NOTE: According to the relation between the outer diameter of rewound ribbon and print speed, ribbon
loss per saving varies as follows: