Filter
Top Products
E6581402c
-13-
5. Specifications
< Environmental specification >
Item Specification
Service environment Conforms to VF-FS1
Operation temperature Conforms to V F-FS1
Storage temperature
-25to+65㷄
Relative humidity 20 to 93% (free from condensation and vapor)
Vibration 5.9m/s
2
(0.6G) or less (10 to 55 Hz) (To be complied with JIS C0040.)
< BACnet option t erminal specification >
Item Specification Note
Communication between
inverter
Applicable model
VF-FS1
Only one board c onnection is
available.
Communication method MODBUS-RTU
Baud rate 19200bps
Parity Even number
Set the inverter parameter
(refer to section 4.1)
Control power supply 5 V
DC
Supplied from inverter
Logic input terminal
2 circuits (F,R)
Slide switch (SW) enable to select
logical configurations (Source/Sink).
Not isolated
Logic output terminal Nothing
Relay contact output
terminal
1 circuit (FL):30V
DC
-0.5A
250V
AC
-1A (cosI=1㧕
250V
A
C
-0.5A (cosI=0.4)
Isolated
Analog input terminals 1 circuit (VIB): 10V
DC
(R
IN
= 30kohm) Not isolated
Analog output terminals Nothing
Power supply output 24V
DC
-50mA Current limit function
< BACnet option net work specification >
Item Specification
Data link / Physical layers Master-Slav e / Token Passing (MS/TP)
Node type Master node
Maximum node 32 nodes per segment
Communication baud rate
9600bps, 19.2kbps, 38.4kbps, 76.8kbps
supports auto-baud detection
Bias resistor and termination
Local bias resistors are mounted.
Termination resistor (120 ohm) can be select by SW.
Terminal block
Detachable terminal block 4-pole (5.08mm pitch)
Manufacturer: PHOENIX C ONTACT
Type-Form : MSTB 2,5/4-ST-5.08