Filter
Top Products
11
Installing the USB Drivers
If you are using the USB(Universal Serial Bus) interface to connect the PCX2600 to
your Windows PC via the USB, you must install the "USB Driver" in your computer.
The USB Drivers for your operating system is located in the CD-ROM shipped with the
PCX2600.
Please note that these USB Drivers only support a computer running Microsoft
Windows 98SE, 2000, Me and XP. These drivers are not supported on the following
operating systems: Windows 98 First Edition; Windows 95 or any earlier version of
Microsoft Windows or DOS OS; Macintosh; Unix/Linux; and IBM OS/2.
Before installing and using these drivers, please be sure to read the "End-User
License Agreement" which is enclosed in the Caution booklet. You will be deemed to
agree to this agreement if you use these drivers.
Preparation
(1)Confirm the PCX2600 is ready by verifying the status panel LEDs.
(See "LED Diagnostics")
(2)Insert the USB Drivers CD-ROM into your CD-ROM drive.
(3)Plug the “Type B” end of the USB cable into the back of the PCX2600.
(4)Plug the “Type A” end of the USB cable into the USB port of your computer.
(5)Turn on your computer.
Installing USB Drivers
(1)After following the instructions described in "Preparation" on this page,
your Windows computer should finish its boot process and display a window
identifying the PCX2600 as a new device and requesting its driver.
(2)Select “Search for the Best Driver for your device" and click “Next”.
(3)Select "CD-ROM drive" and click "Next".
(4)Confirm that the path is correct and click "Next".
Windows should then begin installation.
(5)Click "Finish" to complete the driver installation.
(6)Once this is complete, the process will be repeated for the
“PCX2600…Networking Support”
(7)Once complete, you are ready to surf the internet at warp speed using your new
PCX2600 Cable Modem.