Filter
Top Products
17
Q & A
Q: How to connect the PCX2600 to the hub/switch via the LAN interface ?
A: The PCX2600 is connected to the uplink port on the hub/switch, or use cross-over
Ethernet cable to connect the normal port on the hub/switch. (See below)
Q: How to connect the PCX2600 to the computer via the USB ?
A: Plug the Type A end of the USB cable into the USB port of your computer.
And plug the Type B end of the USB cable into the USB port located in the back of
PCX2600. (See above)
NOTES: Macintosh computers do not support networking through USB.
Mac users must use an Ethernet connection.
Q: Do I need to turn off the PCX2600 ?
A: No. You can leave PCX2600 powered up.
Q: How can I connect multiple computers to the PCX2600 ?
A: You can use LAN and USB interfaces simultaneously, and also can use a hub or
switch for physical connection. The PCX2600 is controlled by the Cable Operator
to allocate how many computers are available. Please contact your local Cable
Operator to activate multiple computers under the PCX2600.
Cross-over Cable
or connect to
uplink port
Cable Modem (PCX2600)
Cable TV Coax
PC
PC
HUB/ Switch
Ethernet
USB Cable