Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33057
2.8 Setting an Operating Environment
E2-34
2.8.1 Parameter Setting
(Cont.)
(26) Pre-Strip Selection
This parameter is to choose whether to activate the Pre Strip function.
When this parameter is set to ON (Available), the top edge of a label is
separated (pre-stripped) from the backing paper before the label is printed.
This function is intended to make the strip issue easier in case the labels
are hard to strip due to the label intensity, adhesive power, or the printing
speed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
This parameter is fixed to OFF.
Press the [PAUSE] key.
(27) Reverse Feed Speed Selection
This parameter is to choose a reverse feed speed.
In the strip issue, the back feed speed of 3”/sec. may cause a shortage of
feed amount due to a lack of torque, slippery media surface, etc. In such
case, reduce the back feed speed to 2”/sec. to secure the feed amount.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Back Feed Speed, press the [PAUSE] key.
<2>PARAMETER SET
BACK SPEED STD
BACK SPEED STD
BACK SPEED LOW
[RESTART]
[FEED]
STD: 3 inch/second
LOW: 2 inch/second
<2>PARAMETER SET
PRE PEEL OFF OFF