Filter
Top Products
©
Toshiba Information Systems (UK( Limited --- Technical Services Department
TOSHIBATOSHIBA
TOSHIBATOSHIBA
TOSHIBA
Page 25
Part Four - Tuning the Qosmio Player (Manual Process)
Step 1
- Using the antenna cable, connect the RF-out socket on the rear of your Sky Digital set top box to the antenna port of the
Qosmio. Refer to Appendix A - Connecting a Qosmio through the Antenna-in Port) for further information.
Step 3
- Press the F1 key - this will display a list of keystrokes along the bottom of the screen.
- Press F2 Setup to display the Qosmio Player setup and configuration screen.
- Using the Up and Down cursor keys ensure that Channel Settings is highlighed on the left hand side of the screen before
pressing the Right cursor key to move to the right hand side of the screen onto the channel configuration options.
- Move down until Manual Channel Programming is highlighed and then press Enter - this will shown the current television
signal together with four boxes along the base of the screen, Input Channel, Display Channel, Actual Channel and Skip.
- With the Input Channel option highlighed, use the Up and Down cursor keys to set it to 6.
- If necessary, move across to the Display Channel option and use the Up and Down cursor keys to set this to 6 also.
- Move across to the Actual Channel and, using the Up and Down cursor keys, move through the channels that are being
received until the Sky Digital signal is displayed - ensure that you note down the channel number, for example 68.
- Move across to the Skip option and, using the Up and Down cursor keys, ensure this is set to Off - this should result in a
configuration similar to the following:-
Input Display Actual
Channel Channel Channel Skip Equates to...
6 6 68 Off Sky Digital
- Once this process has been completed correctly, press Enter followed by F1 - you will now be able to select the Sky Digital
channel by simply pressing 6 on the Qosmio’s keyboard.
Step 2
- With the Qosmio notebook switched off, press the TV
button - this will switch the system on, invoke the Qosmio
Player application and display the current television signal
(by default at first switch on this should be ‘white noise’).
The above photographs show the format of the TV button for the Qosmio F10/10 series,
Qosmio F20 series and Qosmio G20 series respectively