Filter
Top Products
6 SETTING ITEMS
100 User Settings
TX TYPE
Set the fax transmission mode.
EXPOSURE
Set the density at which the original is to be scanned.
TTI
Switch the TTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment in
advance.
P.103 “Registering the terminal ID”
Setting this item may not be required since it may not be displayed on the screen (it depends on your country or
region).
RTI
Switch the RTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment in
advance.
P.103 “Registering the terminal ID”
ECM
Switch the ECM (Error Correction Mode) communication ON or OFF.
ECM is an internationally standardized communication mode that automatically corrects errors that occur during
fax transmissions. With this setting option ON, even when the transmitted data have been affected by noise during
communication, this mode allows good communication without image distortion by automatically resending the part
that have been affected.
y Both the sender and the receiver must have the ECM function to make ECM communication available.
y When affected by noise during communication, communication time is slightly longer than usual. Even
when the ECM communication is used, an error may occur depending on the line status.
y The ECM communication is not available for voice communication.
MEMORY TX: Send the original after the scanned data are saved in the memory. Up to 100 transmissions can
be reserved. Up to 1000 pages can be sent in one transmission.
DIRECT TX: Send the original directly as it is being scanned. Once a page has been scanned and sent, the
next page is scanned and sent. Therefore, it takes longer to scan and send all pages. However,
you can confirm on the fly that each page is sent to the recipient.
AUTO: This equipment automatically detects the contrast of the original, and scans it with the optimum
contrast.
MANUAL: Press or to set the desired contrast.