Toshiba GD-1260 Fax Machine User Manual


 
GD-1150/1151/1200/1201/1160/1260 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
LSU-RELATED FUNCTIONS
2 - 4
1) Discard printing
- Since the trailing edge area of the original is normally blank, this blank area is cut off to allow the
image fit in one sheet in this mode. Image reduction is not performed.
- Maximum discarding amount:
0 mm: Discard not performed
10 mm: Corresponding to the inside the TTI
18 mm: Corresponding to the outside the TTI 1
22 mm: Corresponding to the outside the TTI 2
34 mm: A4 LT conversion
(TTI: Transmission Terminal Identifier)
When the discard function is ON (13–378:1):
Actual size recording is performed with no vertical reduction nor division. The original image is
recorded as it is. Namely, the data exceeding the effective printing area are discarded.
Discard parameter (13-375: 0 to 4)
The following parameters are available:
Reference: These parameters should be set by the service technician (in the FAX Function Mode).
2) Vertical reduction printing (13–377: 0)
- The recording data length is reduced so that the image fits in the recording paper.
The data can be reduced up to 90/75%, and the machine automatically selects the appropriate
ratio.
3) Regular size reduction printing (13–517: 1)
- When the discard and vertical reduction printing cannot be applied to the received image, and
any of the combinations A3 B4, A3 A4, B4 A4, B4 B5, B4 A5, A4 B5, A4 A5,
COMP LT, COMP ST, LD COMP, LD LG/LT, LD ST, LT ST, FOLIO B5, FOLIO
A5 is satisfied, the regular size reduction printing is performed.
In case that the recording data length is within the effective printing length A, but the recording
paper of the same size as the original’s or larger size is not available;
Discard function Length of B (Discard parameter) Set value
OFF 0 mm 0
ON 10 mm 1
18 mm 2
22 mm 3
34 mm 4
A
B
A
Area B is discarded.
A : Effective printing length
B : Recording data length outside the
effective printing area
(
A + B = Recording data length
)