Filter
Top Products
GD-1150/1151/1200/1201/1160/1260 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DIALING/COMMUNICATION CONTROL
3 - 14
2) Standard procedure
Network interaction
(
Phase 1
)
( P3-14)
Final training
(
Phase 4
)
( P3-16)
Control channel
( P3-17)
Primary channel
( P3-18)
Image data
( P3-18)
Probing/Ranging
(
Phase 2
)
( P3-15)
Communication
end procedure
( P3-19)
Equalizer/Echo
canceller training
(
Phase 3
)
( P3-16)
The available modulation mode is in formed.
Each declares that it has V.34 capability. The
procedure moves to V.34 in the phase 2.
After the information about the modem capa-
bility is exchanged, the receiver determines
the modulation speed based on the result of
reception of the probing signal which was sent
by the transmitter.
To determine the image transmission speed,
the transmitter sends a training signal.
The optimum image transmission speed is
determined according to the training signal
received.
The pre-FAX transmission which is the same
as that for the normal T.30 is performed at
1,200 bps.
The post-FAX transmission which is the same
as that for the normal T.30 is performed at
1,200 bps.
The training signal is sent with the determined
parameter, then the image data are sent.
Transmitter Receiver
Line opened
Line closed
Line opened
04/06