Filter
Top Products
4 Replacement Procedures 4.21 GFX board/GFX fin
4-64 [CONFIDENTIAL] TECRA M10 Maintenance Manual (960-685)
Installing the GFX board/GFX fin
To install the GFX board/GFX fin, follow the steps below and refer to Figure 4-38 and 4-39.
1. If there is already cool sheet on the GFX board or GFX fin, remove the cool sheet.
Stick a new cool sheet on the GFX board in place.
NOTE: Do not reuse the cool sheet. Be sure to use a new cool sheet.
2. Set the GFX fin to the GFX board and secure them with the following screws.
• M2.0×3C S-THIN HEAD screw ×4
NOTE: When securing the GFX fin, be sure to secure the screws in the order of the
number marked (1 to 4) on the fin.
3. Connect the GFX board (with the GFX fin) to the connector CN5900 on the system
board slantwise.
4. Push down the GFX board (with the GFX fin) and secure it with following screws.
• M2.0×4B BIND screw ×2