Filter
Top Products
MR-3018/3020/3021/3022 © 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DESCRIPTION OF OPERATIONS
3 - 4
3.1.4 Original exit/reverse motor drive section
Fig. 3-4
When the data of the original have been scanned, the original is exited to the original exit tray by the
exit/reverse roller driven by the exit motor (shown in a solid line in the figure).
In the duplex scanning mode, the gate solenoid is turned ON and the reverse flap is lowered to switch
the transport path to the reverse tray side when the scanning of one side of the original is completed.
When the reverse flap is lowered, the original is temporarily transported to the reverse tray, and then
the exit motor rotates reversely to return the original to the transport path switched for reverse operation
(shown in a dotted line in the figure).
The reversed original is aligned with the reverse registration roller, and then the other side of the origi-
nal is scanned. When the scanning is completed, the original is exited to the original exit tray.
Gate solenoid
Reverse flap
Exit/reverse motor
Exit/reverse roller
Exit
Reverse
06/09