Filter
Top Products
4 Replacement Procedures 4.22 HDD cable/PC card slot
4. Peel the insulator and remove the following screws (on the back of the system
board).
• M2×3S S-THIN HEAD screw ×2
5. Open two latches outward and remove the PC card slot from the system board.
Latch
M2×3S S-THIN HEAD
Insulator
PC card slot
Figure 4-37 Removing the PC card slot
Installing the HDD cable/PC card slot
To install the HDD cable/PC card slot, follow the steps below and refer to Figure 4-36 and 4-
37.
1. Install the PC card slot and secure it with the following screws.
• M2×3S S-THIN HEAD screw ×2
2. Connect the HDD cable to the connector CN1850 on the back of the system board.
3. Install the HDD cable holder on the system board and secure it with the following
screw.
• M2×4B BIND screw ×1
4. Arrange the HDD cable on the HDD cable holder in place.
4-58 [CONFIDENTIAL] PORTÉGÉ M500 Maintenance Manual (960-559)