Filter
Top Products
4.23 LCD unit/FL inverter 4 Replacement Procedures
CAUTION: (continued)
(
1
)
(
2
)
(
3
)
The LCD mask is fixed to the
bezel (metal frame) of LCD with
double-sided tape on the back.
(
4
)
As shown in the figure, the bottom side of the LCD mask is fixed to the LCD
bezel with double-sided tape. If the LCD mask is pulled toward you in
removing it, the bezel may be deformed. When removing the bottom side, be
sure to remove it carefully while removing the double-side tape slowly.
When the bezel of LCD deformed, replace the LCD unit with new one.
When the LCD mask deformed, replace the display mask with new one.
4. Pull out the insulator under the LCD.
5. Remove the FL inverter while peeling off the double-sided tape.
6. Disconnect the cables from the FL inverter.
FL inverter
Insulator
Cable
Figure 4-40 Removing the FL inverter
PORTÉGÉ M500 Maintenance Manual (960-559) [CONFIDENTIAL] 4-61