Filter
Top Products
Problem Procedure
You place a call, but
a connection can’t
be made
Make sure that the settings are correct within your
communication application.
After making a call
you can’t hear a ring
Ensure that the communication application's tone
or pule dialling selection feature is set correctly.
Communication is
cut off unexpectedly
The computer will automatically cut off
communication when connection with the carrier is
not successful for a set time interval - try
lengthening this time interval within your
communication application.
A CONNECT display
is quickly replaced
by NO CARRIER
Ensure that the communication application's error
control feature is set correctly.
Character display
becomes garbled
during a
communication
When transmitting data you should ensure that the
parity bit and stop bit settings correspond with
those of the remote computer - you should check
the flow control and communication protocol
settings within your communication application.
You cannot receive
an incoming call
Ensure that the communication application's rings
before auto answer feature is set correctly.
If you are still unable to resolve the problem,
contact your reseller, dealer or service provider.
LAN
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN hub.
Wake-up on LAN
does not work
Make sure the AC adaptor is connected. The
Wake-up on LAN function consumes power even
when the system is off.
If problems persist, consult your LAN administrator.
Wireless LAN
If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 3, Operating Basics.
User's Manual
6-18