Filter
Top Products
Chapter 2 Troubleshooting Procedures
Satellite T110 / Satellite Pro T110 / PORTEGE T110 Maintenance Manual (960-Q08)
15
Procedure 2 Message Check
When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
n.
Turn on the computer and check the message on the screen. When an OS starts from the 2.5”
HDD, go to Procedure 3. Otherwise, start with Check 1 below and perform the other checks
as instructe
Check 1 ages appears, go to Check 2. If the following
Press any key when ready .....
or
Check 2 Using the SYS command of the Free-DOS; transfer the system to the 2.5” HDD.
If the system is not transferred, go to Procedure 3. Refer to the Free-DOS Manual
Check 3
sert
connector(s) firm
ly. If it is (or they are) firmly connected, go to
Procedure 3.
in the BIOS ROM. When the test detects an error, an error message is displayed on the scree
d.
If either of the following mess
messages do not appear, perform Check 3.
Insert system disk in drive
Non-System disk or disk error
Replace and press any key when ready
for detailed operation.
If the following message appears on the display, the system program has been
transferred to the HDD.
System Transferred
If an error message appears on the display, perform Check 3.
2.5” HDD(s) and the connector(s) of system board may be defective (Refer to the
steps described in Chapter 4, Replacement Procedures for disassembling.). In
HDD(s) to the