Filter
Top Products
33
Operations
CONTENTS
Turning the power off
Press ON/STANDBY after using the projector.
An instruction message for turning the power off appears on
the screen and disappears after a while. When the message
disappears, operation becomes invalid.
Press ON/STANDBY again.
Cooling starts. Once cooling is completed, the LAMP and FAN
indicators turn off and the standby mode is set. (The ON
indicator turns in orange.)
To protect the light source lamp, the LAMP indicator blinks as long as
a minimum of cooling is necessary. The power cannot be turned back
on during this time. Unplugging the power cord at this time will shorten
the lamp’s duration life.
The cooling fan continues to run for a while to expel the heat remaining
inside. If you are in a hurry, however, you may unplug the power cord
at this time.
The standby mode is set.
1
2
K
E
Y
S
T
O
N
E
A
U
T
O
S
E
T
E
X
I
T
ON / STANDBY
VOL / ADJ
E
N
T
E
R
M
E
N
U
I
N
P
U
T
F
A
N
T
E
M
P
L
A
M
P
O
N
2
1,2
MENU
ON/STANDBYINPUT
L-CLICK R-CLICK
ENTER
KEYSTONE
AUTO
SET
EXIT
PIP
FREEZE
MUTECALL
RESIZE
VOLUME/ADJUST
LASER
1,2
(Green)
(Green) (Green)
(Off)
(Off)(Off)
Flashing
(Orange) (Orange)
A B C
ON
LAMP
FAN
ON
LAMP
FAN
ON
LAMP
FAN
(Orange)
ON/STANDBY
ON/STANDBY
ON/STANDBY
ON/STANDBY
B
C
A
Notes
• The projector consumes about 20W of power in the standby mode. We recommend you
unplug the power cord when not using the projector for long periods of time.
• Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the
power by unplugging the power cord while the projector is operating or the light source lamp is
being cooled will shorten the lamp’s duration life. Should a fault or some other irregularity
arise with this unit, unplug the power cord.
• When reinserting the power plug before the lamp has cooled, please wait until the lamp has
cooled sufficiently before use. When the lamp is at a high temperature, it may not light and it’s
life duration will be shortened.
Remote control
Control panel
(Main unit side)
Indicators