Filter
Top Products
Arche r D9
AC1900 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
Connect on demand: This mode is dependent on the traffic. If there is no traffic (or Idle ) for a
pre-specified period of time (MAX Idle Time), the connection will drop down automatically.
And once there is a request for Internet connection, it will be on automatically.
Connect Manually: You can manually control the status of a connection. This mode also
supports the Max Idle Time function as Connect on Demand mode. The Internet connection
can be disconnected automatically after a specified inactivity period and re-established when
you attempt to access the Internet again.
Authentication Type : Select the Authentication Type from the drop-down list, the default
method is AUTO_AUTH, and you can leave it as a default setting.
Enable IPv4: Check this box to enable IPv4.
Enable IPv6: Check this box to enable IPv6.
Default Gateway: Select a WAN connection from the drop-down list as the IPv4 default
gateway.
IPv6 Default Gateway: Select a WAN connection from the drop-down list as the IPv6 default
gateway.
Click Advance, advanced selections for WAN Service Setup can be shown.
Service Name/Server Name: Enter the Service Name and Server Name if it was provided by
your ISP. You can leave them blank, if the ISP doesn’t provide them.
M TU (bytes): The default M TU (Maximum Transmission Unit) value is 1480 Bytes. Do not
change the default value unless required by your ISP.
Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.
Enable SPI Firewall: The SPI firewall enhances network’s security. Select the option to use a
firewall, or else without a firewall.
Enable IGMP Proxy: IGMP (Internet Group Management Protocol) is used to manage
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration for
client devices, such as the modem router. It is enabled by default.
Use IP address specified by ISP: Select this option and enter the IP address provided by
your ISP.
Set DNS Server manually: Choose “Set DNS Server manually”, you can set DNS Server
manually here. The modem router will use this DNS Server for priority.
Use IPv 6 address specified by ISP: Choose “Use IPv6 address specified by ISP”, you can
enter the IPv6 address provided by your ISP.
Set IPv6 DNS Server manually: Choose “Set IPv6 DNS Server manually”, you can set IPv6
DNS Server manually here. The modem router will use this IPv6 DNS Server for priority.
Click the Save button to save the settings.
4.5.1.4 PPPoA
If your ISP provides a PPPoA connection and you need to use an ATM Interface, choose PPPoA
in the drop-down list, and then the screen will be displayed as below.
The configuration is similar to PPPoE. Please refer to the section 4.5.1.3 PPPoE
to configure this
part.
25