Filter
Top Products
Syntax
speed { 10 | 100 | 1000 | auto }
no speed
Parameter
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are four
options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode (default).
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Speed Mode as 100Mbps for port 3:
TL-SG2424(config)# interface gigabitEthernet 1/0/3
TL-SG2424(config-if)# speed 100
storm-control broadcast
For TL-SG2216/TL-SG2424/TL-SG2424P:
Description
The storm-control broadcast command is used to enable the broadcast
control function. To disable the broadcast control function, please use no
storm-control broadcast command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth, the packets will be automatically discarded
to avoid network broadcast storm.
Syntax
storm-control broadcast [rate rate]
no storm-control broadcast
Parameter
rate —— Specify the bandwidth for receiving broadcast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. The value of it can be
128k | 256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default,
the value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
92