Filter
Top Products
storm-control unicast
For TL-SG2216/TL-SG2424/TL-SG2424P:
Description
The storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use no storm-control
unicast command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control unicast [rate rate]
no storm-control unicast
Parameter
rate —— Specify the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default, the
value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# storm-control unicast
For TL-SG2452:
Description
The storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use no storm-control
unicast command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth in the storm-control rate
, the packets will be automatically
discarded to avoid network broadcast storm.
Syntax
storm-control unicast
95