Filter
Top Products
12
Figure 3-11 Quick Setup - Wireless settings
¾ SSID - Enter a value of up to 32 characters. The same SSID must be assigned to all
wireless devices on your network. The default SSID is TP-LINK. This value is
case-sensitive. For example, TP-LINK is NOT the same as tp-link.
¾ Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the router can be used. It may be illegal to use the wireless function of the
router in a region other than one of those specified in this field.
¾ Channel - The current channel in use. This field determines which operating frequency
will be used.
¾ Mode - Indicates the current mode 54Mbps (802.11g), 11Mbps (802.11b). If you select
54Mbps (802.11g), it is compatible with 11Mbps (802.11b).
These settings are only for basic wireless parameters, for advanced settings, please refer to
Section 4.6: "Wireless."
B. When you choose AP mode on Quick Setup - Choose Operation Mode page (shown as
Figure 3-6), you will directly go to the Wireless page as Figure 3-11 above.
C
lick the Next button. You will then see the Finish page:
Figure 3-12 Quick Setup - Finish
After finishing all configurations of basic network parameters, please click Finish button to exit
this Quick Setup and wait your device reboot automatically. The changes of wireless settings will
take effect after rebooting.