Filter
Top Products
Loading NetWare ODI Drivers 4-11
For complete details on loading the NetWare 4.x server driver
for your NetWare version, refer to the README files, which are
in the \NETWARE\SERVER subdirectory on the EtherDisk
diskette. The readme files are named as shown below:
README.40X
README.41
README.311
README.312
2 When you start the server, enter the following commands:
For NetWare 3.11:
LOAD C:LSLENH.NLM [Enter]
LOAD C:3C59X.LAN PORT=XXXX [Enter]
BIND IPX TO 3C59X NET=XXXX [Enter]
For NetWare 3.12, 4.0x, or 4.x:
LOAD C:3C59X.LAN PORT=XXXX [Enter]
BIND IPX TO 3C59X NET=XXXX [Enter]
where XXXX is the adapter’s port address. (To determine the
port address, multiply the slot number by 1000 hex. If the
adapter is installed in slot number three, for example, multiply
3 by 1000 hex = 3000 hex.)
When running the 3C59X.LAN driver with NetWare 3.11 you must
update the MONITOR.NLM file that accompanied NetWare 3.11
with the MONITOR.NLM file from Novell. For the latest NLMs,
contact Novell.
Multiple Adapters in a Server
If you are running NetWare and have installed multiple adapters
in an EISA computer that is functioning as a server, follow the
instructions in this section to load the NetWare 4.x server driver.
The 3C59X EtherDisk diskette contains a NetWare 4.x server driver
(3C59X.LAN) and the NetWare Loadable Modules (NLMs) that
enable the NetWare 4.x driver to be used with NetWare 3.11, 3.12,
or 4.0x software. These files are found in the \NETWARE\SERVER
subdirectory.