Filter
Top Products
T
T
T
S
S
S
3
3
3
2
2
2
M
M
M
~
~
~
1
1
1
G
G
G
C
C
C
F
F
F
8
8
8
0
0
0
80X CompactFlash Card
Transcend Information Inc.
71
If an error occurs during a write of more than one sector, writing terminates at the sector where the error occurs. The
Command Block Registers contain the cylinder, head and sector number of the sector where the error occurred. The host
may then read the command block to determine what error has occurred, and on which sector.
5.6.30 Write Sector(s) without Erase - 38h
This command is similar to the Write Sector(s) command with the exception that an implied erase before write operation
is not performed. This command has the same protocol as the Write Sector(s) command. The sectors should be
pre-erased with the Erase Sector(s) command before this command is issued. If the sector is not pre-erased with the
Erase Sector(s) command, a normal write sector operation will occur.
5.6.31 Write Verify - 3Ch
This command is similar to the Write Sector(s) command, except each sector is verified immediately after being written.
This command has the same protocol as the Write Sector(s) command.