Filter
Top Products
Transition Networks
Appendix D:
IP-Based and Chassis Management Parameters
IP- and chassis-
based
management
The chassis Device version of the Devices plugs into a Point System chassis to
provide management through the I
2
C interface: SNMP and web-based management
through the MMU. SNMP management is based on the Transition Networks
enterprise MIBs. The chassis-based management (via the MMU) provides a subset of
the IP-based management via ports. Tables 26, 27, and 28 present IP- and chassis-
based configuration management parameters.
Note: The 9 mark means available; a blank cell means not available.
Table 24: System Configuration Parameters
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 129
Parameter IP based Chassis Description
9 9
The currently installed version of the
Bootloader.
BootLoader
Version
Config Match
9 9
Configuration management match.
Default Gateway
9 9
The gateway in a network that will be
used to access another network if a
gateway is not specified for use.
DHCP
9 9
DHCP (Dynamic Host Configuration
Protocol) Enable/disable DHCP to obtain
IP, subnet mask, and gateway data upon
reboot.
Firmware Version
9 9
The currently installed version of the
firmware.
IP Address
IP address of the Device.
9 9
IP Traffic Access
Enable/disable IP Traffic to the Device.
9 9
MAC Address
9 9
The MAC address is a
unique identifier
attached to most
network adapter NICs. It
is a number that acts like the name for a
particular network adapter.
9
Management
VLAN ID
Thru CLI
only
When 802.1q is enabled, the administrator
can configure VLAN IDs used for all
management traffic to and from the
Device via the CLI or through the chassis
management agent.
9 9
Marketing
Revision
Marketing revision.
9
Enable/disable RADIUS authentication.
When enabled, the user is authenticated
during login at the CLI or web interface.
RADIUS
Authentication
Continued on next page