Filter
Top Products
* Typical maximum cable distance. Actual distance is dependent upon the physical
characteristics of the network.
Part Number Port One - Copper Port Two - Duplex Fiber-Optic
SCSCF3011-100 75 ohm coax (BNC) ST, 1300 nm multimode
2 km (1.2 miles)*
SCSCF3013-100 75 ohm coax (BNC) SC, 1300 nm multimode
2 km (1.2 miles)*
SCSCF3014-100 75 ohm coax (BNC) SC, 1310 nm singlemode
20 km (12.4 miles)*
SCSCF3015-100 75 ohm coax (BNC) SC, 1310 nm singlemode
40 km (24.8 miles)*
SCSCF3016-100 75 ohm coax (BNC) SC, 1310 nm singlemode
60 km (37.3 miles)*
SCSCF3017-100 75 ohm coax (BNC) SC, 1550 nm singlemode
80 km (49.7 miles)*
SCSCF3018-100 75 ohm coax (BNC) MT-RJ, 1300 nm multimode
2 km (1.2 miles)*
SCSCF3019-100 75 ohm coax (BNC) LC, 1310 nm single mode
20 km (12.4 miles)*
SCSCF3029-100 75 ohm coax (BNC) SC, 1310 mn (TX)/1550 nm (RX)
20 km (12.4 miles)*
SCSCF3029-101 75 ohm coax (BNC) SC, 1550 mn (TX)/1310 nm (RX)
20 km (12.4 miles)*
SCSCF3029-100 and -101 are intended to be installed in the same network where
one is the local converter and the other is the remote converter.
User’s Guide
SCSCF30xx-10x
Stand-Alone Device
• DS3 or T3 / E3
• Coax (BNC) to Fiber
Transition Networks SCSCF30xx-10x series
Devices encode and decode DS3 or E3 coax
copper signals over fiber optic cable to extend
the distance and transmission reliability of high-
speed DS3 or E3 data traffic. The SCSCF30xx-
10x also connects remote locations via T3/E3
cable.
Note: The CCSCF30xx-10x model is the
chassis version of the Device. For more
information, see the CCSCF30xx-10x user’s
guide on-line at www.transition.com.
Installation . . . . . . . . . . . . . . . . . . . . .2
Operation . . . . . . . . . . . . . . . . . . . . . .6
Cable Specifications . . . . . . . . . . . . . .7
Technical Specifications . . . . . . . . . . .8
Troubleshooting . . . . . . . . . . . . . . . . .9
Compliance Information . . . . . . . . .12