Filter
Top Products
1. Introduction and 2. Safety information
7. Do not use the circulator beyond its specifications or for
other than its intended use.
8. Do not touch the stainless steel bath cover and tubings
when the unit is used at a high working temperature. Under
these conditions, the surface temperature can rise up to
approximately 70 °C.
MultiTemp III is designed in accordance with:
• Protection class 1 according to IEC 536: all conductive
parts that might become accessible are connected to earth.
• Protection IP 32 according to IEC 529/EN 60529: protec-
tion against accidentally touching accessible live parts by
penetration of particles with a thickness or a diameter of
more than 2.5 mm and protection against dropping water
onto the unit, inclined at max. 15 degree angle.
This product meets the following EG directives:
• 72/23/EEC through the harmonised standard;
EN 61010-1, Safety requirements for electrical equipment
for measurement, control and laboratory use.
- Part 1: General requirements.
- Part 2: Requirements for laboratory Equipment for hea-
ting of material.
Note: the operator has to apply the safety precautions lis-
ted in section 2.1 above.
• 89/336/EEC through the standards;
- EN 50081/Part 1:03.93 Electromagnetic Compatibility
emission standard
- EN 50082/Part 1:03.93 Electromagnetic Compatibility,
Generic immunity standard.
The CE symbol, and corresponding declaration of confir-
mity, is valid for the instrument when it is
- used as a “stand alone” unit or
- connected to other CE marked Pharmacia Biotech
instruments or
- connected to other products recommended or descri-
bed in this manual and
- is used in the same state as it was delivered from
Pharmacia Biotech AB except for alterations described in
this manual.
4
2.2 Safety
standards