Filter
Top Products
User Manual
TEW-455APBO High Power Wireless Outdoor PoE Access Point
36
Note that VLAN ID in the WDS MAC List setting will only be tagged to egress packets on the wired Ethernet port. Ensure to
match VLAN ID used on the network of the peer. WDS link won’t carry tags at all.
WMM: By default, it’s “Disable”.
Select “Enable”, then packets with WMM QoS will take higher priority.
WMM prioritizes traffic according to four Access Categories (AC) - voice, video, best effort, and
background. However, it does not provide guaranteed throughput. Packets with QOS header including
Diffserv/IP TOS and 802.1p will be mapped into 4 Access Categories of WMM, packets without QOS header
will be assigned to Best Effort queue, see table below. 802.1p/IP TOS mapping to WMM:
Queue
Data Transmitted
Clients to AP
IP
TOS
802.1P
Priority
Priority
Description
AC_BK
Background.
0x08
0x20
1, 2
Low
High throughput. Bulk data that requires maximum
throughput and is not time-sensitive is sent to this
queue (FTP data, for example).
AC_BE
Best Effort
0, 3
Medium
Medium throughput and delay. Most traditional IP
data is sent to this queue
AC_VI
Video
0x28
0xa0
4, 5
High
Minimum delay. Time-sensitive video data is
automatically sent to this queue
AC_VO
Voice
0x30
0xe0
0x88
0xb8
6, 7
High
Time-sensitive data like VoIP and streaming media are
automatically sent to this queue
Security Type: Options are “Disabled”, “WEP”, and “AES” from the drop-down list. All devices need to have
the same security setting to build WDS link.
WEP Key: Enter HEX or ASCII WEP key at different length as shown below. This system supports up to
4 sets of WEP keys.