Filter
Top Products
2
2. Hardware Installation
3. Verify that the following panel lights are on:
Note:
1: Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or
access point. If you would like to use WPS push button setup, please go directly to
section 4. Wi-Fi Protected Setup (WPS) Push Button Setup. If your wireless router
or access point does not support WPS, continue on to section 2 in the Hardware
Installation.
2: Do not connect/install the TEW-640MB to your network until instructed to do so.
1. Connect one end of the provided RJ-45
network cable to one of the TEW-640MB's LAN
ports. Connect the other end of the cable to
your computer's network port.
2. Connect the Power Adapter to the TEW-640MB
and then to a power outlet. EU Versions will
have a power button on the back. Push the
power button to the “On” position (EU Version).
Wait 30 seconds for the TEW-640MB to boot
up.
Network Port (1-4) (Blue/Blinking)
Wireless (Blue/Blinking)
Power (Blue/Solid)