Filter
Top Products
7
4. Wi-Fi Protected Setup (WPS) Push Button Setup
Note:
1: Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or
access point.
2: Do not connect/install the TEW-640MB to your network until instructed to do so.
Make sure your network adapter settings are set to obtain an IP address
automatically (see troubleshooting section).
1. Find a location where you would like to place
the TEW-640MB. The location must be within
the wireless coverage of your router or access
point. Please refer to the wireless tips sections
for additional information.
5. Once the WPS button becomes steady blue
(approximately within 120 seconds), the
TEW-640MB has been successfully configured.
4. Within 60 seconds press and hold the WPS
button on the TEW-640MB for 2 seconds. The
WPS button will start to blink.
3. Press and hold the WPS button on your
wireless router or access point for 2 seconds.
The example shows a TEW-690AP access
point.
2. Connect the Power Adapter to the TEW-640MB
and then to a power outlet. EU Versions will
have a power button on the back. Push the
power button to the “On” position (EU Version).
Wait 30 seconds for the TEW-640MB to boot
up.