Filter
Top Products
2.4 Adding the Powerline Adapter to an Existing Powerline Network
The procedure describes how to add the TPL-307E 200Mbps Powerline AV Adapter with
Bonus Outlet to an existing powerline network.
Assuming the two TPL-307E powerline adapters are currently connected to each other
and the third TPL-307E (Additional) powerline adapter is currently disconnected.
1. Push and hold the Sync button on the additional TPL-307E powerline adapter for 10
seconds and release it. All LEDs will turn off and turn back on. This will erase the
current network name/security key assigned to the additional TPL-307E powerline
adapter.
2. Push and hold the Sync button on one of the two TPL-307E powerline adapters that
are currently connected to each other for 2 seconds and release it. The PWR LED will
start blinking.
3. Within 2 minutes (120 sec), push and hold the Sync button on the additional TPL-307E
for 2 seconds and release it. The PWR LED will start blinking. This will establish
connectivity between the three powerline adapters by assigning the additional TPL-
307E powerline adapter’s network name/security key to match the network
name/security key of the TPL-307E powerline adapters that are currently connected.
4. To verify connectivity between the three powerline adapters, make sure that the PL
LED on each powerline adapter is on solid (Green, Amber, Red). Please refer to the LED
section 1.5 for details on the LED indicator.