Filter
Top Products
MOPS/586 User Information
Warranty
Each board is tested carefully and thoroughly before being shipped. If, however, problems should occur during
the operation, please check your user specific settings of all boards included in your system. This is often the
source of the fault. If a board is defective, it can be sent to your supplier for repair. Please take care of the
following steps:
1. The board returned should have the factory default settings since a test is only possible with these
settings.
2. In order to repair your board as fast as possible we require some additional information from you.
Please fill out the attached Repair Form and include it with the defective board.
3. If possible the board will be upgraded to the latest version without additional cost.
4. Upon receipt of the board please be aware that your user specific settings were changed during the
test.
Within the warranty period the repair is free of charge as long as the warranty conditions are observed. Because
of the high test expenditure you will be charged with the test cost if no fault is found. Repair after the warranty
period will be charged.
This JUMPtec
®
product is warranted against defects in material and workmanship for the warranty period from
the date of shipment. During the warranty period JUMPtec
®
will at its option either repair or replace defective
products.
For warranty service or repair the product must be returned to a service facility designated by JUMPtec
®
.
The foregoing warranty shall not apply to defects resulting from improper or inadequate maintenance or
handling by buyer, unauthorized modification or misuse, operation outside of the product´s environmental
specifications or improper installation or maintenance.
JUMPtec
®
will not be responsible for any defects or damages to other products not supplied by JUMPtec
®
that
are caused by a faulty JUMPtec
®
product.
Introduction
The MOPS/586 integrates the complete functionality of an 80486 motherboard with CPU, System-BIOS, 8
Mbyte to 32 MByte DRAM, keyboard-controller, real time clock and additional peripheral functions like COM1,
COM2, LPT1, Floppy-interface, EIDE-harddisk-interface, watchdog and optional Ethernet access. The system
runs with CPU clock speed 133MHz.
Tri-M Systems Inc., 6-1301 Ketch Court, Coquitlam, B.C., V3K 6X7, Canada
Phone: (604) 527-1100, (800) 665-5600 Fax: (604) 527-1110
Email: info@Tri-M.com Web: www.Tri-M.com