Filter
Top Products
8
Basic Operation
continued
Other UPS Features (Rear Panel)
AC Receptacles
Your UPS features 15-amp AC outlets. These output receptacles provide your
connected equipment with AC line power during normal operation and battery
power during blackouts and brownouts. The UPS protects equipment connected
to these receptacles against damaging surges and line noise. If you have a network
connection to your UPS, you can remotely reboot connected equipment by turning
the receptacles OFF and ON using Tripp Lite UPS software. Select models also
feature a specially labeled “Load Control” receptacle that can be turned ON and
OFF independently of the other receptacles using Tripp Lite UPS software. See
software instructions for details.
Smart DB9 Serial Port
Your UPS features a DB9 port that may be used to connect the UPS to a DB9
port on any workstation or server. It uses RS-232 protocol to communicate UPS
status and power conditions. Use with Tripp Lite cabling and PowerAlert
Software to remotely monitor and manage power and automatically save open
files and shut down equipment during a blackout. See Connection section.
Smart USB Port
Your UPS has a USB port that may be used to connect the UPS to a USB port
on any workstation or server. It uses USB protocol to communicate UPS status
and power conditions. Use with Tripp Lite cabling and PowerAlert Software to
remotely monitor and manage power and automatically save open files and shut
down equipment during a blackout. See Connection section.
EPO (Emergency Power Off) Port
Your UPS features a EPO port that may be used to connect the UPS to a switch
to enable emergency inverter shutdown. See Connection.
SNMP Accessory Slot
Remove the small cover panel from this slot to install optional accessories to
remotely monitor and control your UPS. Refer to your accessory’s manual for
installation instructions. Contact Tripp Lite Customer Support at (773) 869-1234 for
more information, including a list of available SNMP, network management and
connectivity products.
Ground Lug
Use this to connect any equipment that requires a chassis ground.
200210187 Smart 700-1000 RM1U Owner’s Manual 93-2102.qxd 11/1/2002 9:50 AM Page 8