Filter
Top Products
55
For SMX Models Only—“POWER” Button:
• To turn the UPS ON: with the UPS plugged into a live AC wall outlet,*
press and hold the POWER button for about two seconds.** Release the
button. If utility power is absent, you can “cold-start” the UPS (i.e.: turn
it ON and supply power for a limited time from its batteries***) by pressing
and holding the POWER button for about two seconds.**
• To turn the UPS OFF: with the UPS ON and receiving utility power,
press and hold the POWER button for one second.** Then unplug the
UPS from the wall outlet. The UPS will be completely OFF.
*After you plug the UPS into a live AC outlet, the UPS will automatically charge its batteries,
but will not supply power to its outlets until it is turned ON. ** The alarm will beep once briefly
after the indicated interval has passed. *** If fully charged.
For OMNIX Models Only—“UPS/STANDBY” Button:
Use the UPS/STANDBY button to do three things:
Switch your UPS’s Operating Mode: While your UPS is plugged into a
live AC outlet, press the UPS/STANDBY button and hold it until you hear
a beep (about 2 seconds) to toggle between the following operating modes.
Choose your UPS’s operating mode based on the regional guidelines in
Step 3 of the Quick Installation section.
• UPS Mode: ENABLES battery backup. UPS Conditions: While receiv-
ing adequate utility line power, the UPS supplies power to its AC recep-
tacles and charges its batteries; its “POWER” indicator light will be lit.
If the utility line power fails or becomes inadequate, the UPS will supply
inverted AC power to its receptacles if its batteries are sufficiently
charged. Setting Advantages: Provides battery backup during blackouts
or brownouts.
• STANDBY Mode: DISABLES battery backup. UPS Conditions: While
receiving adequate utility line power, the UPS supplies power to its AC
receptacles and charges its batteries; the “POWER” indicator light will
be flashing. Setting Advantages: Continues to charge the battery when
power is present while turning OFF the inverter to prevent battery deple-
tion during power outages when equipment is not in use.
Cold-Start Your UPS: You may “cold start” your UPS and use it as a
stand-alone power source when utility power is not present, providing that
the UPS battery is charged. To “cold start” your UPS, press and hold the
UPS/STANDBY button until you hear a beep (about 2 seconds), then
release it. The “BATTERY CHARGE/BATTERY POWER” indicator light
will illuminate and AC power inverted from stored battery power will be
provided at the UPS receptacles.
Shut Down Your UPS: Press and hold the UPS/STANDBY button when
AC line power is absent (i.e. during a blackout, or when the UPS is
unplugged) to deactivate your UPS.
Buttons
Basic Operation
200711093 93-2745 230V HG UPS OM.qxd 12/17/2007 9:39 AM Page 5