Filter
Top Products
44
http://www.TYAN.com
3. Secure the hard disk drive to the bracket with four bottom screws.
4. Fit the bracket with the hard disk drive back into place and secure with one screw.
5. Connect one end of the data cable to the secondary IDE connector (see figure above) and the
other end to the rear of the hard disk drive.
NOTE: Connect the data cable to the secondary RAID IDE connector if using RAID disk
drive.
6. Connect the power cord to the rear of the hard disk drive.
7. You can create RAID for the hard disk drives (see Chapter 7 for information).
Secondary IDE Connector