Filter
Top Products
Elo TouchSystems 19R series User Guide 47
EMC Directive 2004/108/EC indicated in European Standard EN 55 022 Class A and the
Low Voltage Directive 2006/95/EC as indicated in European Standard EN 60 950.
D) General Information to all Users: This equipment generates, uses and can radiate
radio frequency energy. If not installed and used according to this manual the equip-
ment may cause interference with radio and television communications. There is, how-
ever, no guarantee that interference will not occur in any particular installation due to
site-specific factors.
1) In order to meet emission and immunity requirements, the user must observe
the following:
a) Use only the provided I/O cables to connect this digital device with any
computer.
b) To ensure compliance, use only the provided manufacturer’s approved line
cord.
c) The user is cautioned that changes or modifications to the equipment not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
2) If this equipment appears to cause interference with radio or television recep-
tion, or any other device:
a) Verify as an emission source by turning the equipment off and on.
b) If you determine that this equipment is causing the interference, try to correct
the interference by using one or more of the following measures:
i) Move the digital device away from the affected receiver.
ii) Reposition (turn) the digital device with respect to the affected receiver.
iii) Reorient the affected receiver’s antenna.
iv) Plug the digital device into a different AC outlet so the digital device and
the receiver are on different branch circuits.
v) Disconnect and remove any I/O cables that the digital device does not
use. (Unterminated I/O cables are a potential source of high RF emission
levels.)
vi) Plug the digital device into only a grounded outlet receptacle. Do not
use AC adapter plugs. (Removing or cutting the line cord ground may in-
crease RF emission levels and may also present a lethal shock hazard to the
user.)
vii) If you need additional help, consult your dealer, manufacturer, or an
experienced radio or television technician.