Filter
Top Products
DIP-Switch Setup
The DIP-switch is used to configure full- or Half-duplex switching. The DIP-
switch setup is as follows:
Position Description
UP: Enables Full-Duplex Operation for 100Based-FX ports
(default)
DOWN: Enables Half-Duplex Operation for 100Based-FX ports
6
Figure 2. LED view of Pro-Switch/8F
Power On
Connect the power cord to the power socket on the rear panel of the
Switch. The other side of power cord connects to the power outlet. The
internal power supply in the Switch works with AC in the voltage range 100-
240VAC, frequency 50~60Hz. Check the power indicator on the front panel
to see if power is properly supplied.
11