Filter
Top Products
22
Setting Up Your Scanner
the scanner's DC 6V jack (see “Using AC Power” on
Page 23).
WARNING!
Do not connect either adapter to the scanner if non-
rechargeable batteries (such as alkaline batteries)
are installed in the scanner and REG. ALK. BATT./
NI-MH BATT. is set to NI-MH BATT., or if you are
unsure of the switch’s position. Non-rechargeable
batteries will get hot and can even burst if you try to
recharge them.
Before you use Ni-MH or Ni-Cd batteries for the first
time, charge them for 14 hours to bring them to a full
charge.
Discharged batteries take about 14 hours to fully
recharge.
Notes:
• Ni-MH batteries last longer and deliver more
power if you occasionally let them fully
discharge. To do this, simply use the scanner
until it beeps every 15 seconds and
flashes.
• To prevent damage to Ni-MH batteries, never
charge them in an area where the temperature is
above 113°F (45°C) or below 40°F (4°C).
• For longer operation, you can also use high-
capacity Ni-MH batteries to power the scanner.
This type of battery takes longer to recharge.
You can get high-capacity Ni-MH batteries at
your local electronics store.